Instructions for the use of products:
Put the stop pin on the road - the direction of the traction device unfolding - open the lock on both sides - open the power switch of the traction device (the red key is on standby).
Pull out the antenna of the remote controller - press the forward button (front side), expand the nail belt to the required length and release the button.
When closing, press the back button (back) and press the back button to release your hands.
General fault diagnosis and maintenance:
1. In case of remote control failure, please follow the following steps to check:
Check whether the power supply of the remote controller is normal (whether the battery of the remote controller needs to be replaced).
Check the power supply of equipment box is normal. The main lithium batteries can be recharged once normally, and can be retrieved and placed more than 100 times or standby for more than 100 hours continuously. If the working efficiency of the equipment is greatly reduced, the replacement of new batteries should be considered.
Check whether the circuit board is normal (when the power is turned on, the circuit board indicator is on).
2. If the nail strip (aluminium strip) can not be retracted properly due to its deformation, please adjust the deformed aluminium strip manually and straighten it to return to normal.
3. This product is a mechanical and electrical product. If you can't resume normal use under special circumstances, please contact the supplier according to professional skills.
4. Operators of roadblock facilities prompt troubleshooting, and non-professionals are strictly forbidden to disassemble themselves.
Product specifications and indicators:
Outer case size: 550 mm x 425 mm x 80 mm.
Equipment weight: 8 kg.
Remote Control Speed: Deploy within 5 seconds, 7 meters within 5 seconds, and recover within 7 meters. The required length is optional.
Remote control range: 50 meters.
Nail length: 4.5mm.
Charging rules: the first three charges need to be charged for 12 hours each time. More than 100 consecutive receiving and placing operations and more than 100 consecutive standby hours. The charger indicates that the charge is being charged when the red light is on and the charge is completed when the green light is on.