(The picture is a regular one. Reflective bars and lights can be added to the speed reducer. Active luminescence can be used to warn at night and when the light is not strong.)
1. Product introduction: 2C portable remote control obstacle is composed of high-performance reinforced plastic block and stainless steel exhaust hollow needle. It adopts electromechanical remote control device. It is easy to operate, safe and reliable. It can set up cards at any time, mobile defense, and does not affect the normal road smooth. It is the relevant law enforcement department. It is necessary to set up cards to intercept suspect vehicles. Advanced equipment is indispensable for vehicle operation.
II. Usage
1. Make sure that the batteries in the remote control box are charged for enough time before use, so that the voltage of the power supply is kept between 11V and 13.5V.
2. In the section where the interception task is needed, open the box cover on the right side of the packing box of the blocking roadblock, roll out the obstacle roll, remove the loose hook used for fixing the roadblock, lean on the side of the roadside and roll towards the road surface of the vehicle to be intercepted.
3. Connect the wiring between the remote control box and the roadblock head, insert one end of the two-meter three-core connecting cable into the roadblock head connecting jack, and the other end into the remote control box three-core connecting jack.
4. Open the top cover of the remote control box, pull the power switch to the built-in power supply, light the power indicator, and the equipment enters the working state. Pull the left receiving antenna out and erect to increase the receiving distance.
5. When it is necessary to perform the task of intercepting suspect vehicles, press the big button at the top of the remote controller, and emit a "beep" sound in the power box. The stainless steel hollow needle in the roadblock will be automatically erected. At this time, if forced through the roadblock, the wheel will be pierced into several stainless steel hollow needles. The tire will deflate immediately within two seconds and can not continue. Driving, parking only.
6. After the interception mission, press the small button at the lower end of the remote control, and the stainless steel hollow needle will rotate back to its original position and turn into standby state.
7. Recovery of remote control obstacle block, after rolling the block round, fix the block with loose hook belt, close the power switch of remote control box, put the remote control box into the middle space of the block, hold the box with left hand, roll the block into the box with right hand, put the connecting cable and fasten the lid of the box.
8. The remote control roadblock is also equipped with an external power supply connection. When the power supply voltage in the remote control box is insufficient and can not work normally, one end of the automobile connecting cable can be inserted into the external power supply connection jack of the remote control box, the other end can be inserted into the 12V automobile cigarette lighter jack, and the power switch of the remote control box can be pulled out to the external power supply position. The above methods are the same.
9. Working indicator
(1) Power Indicator - When the remote control roadblock needs to perform the interception task, turn on the power switch in the remote control box, and the power indicator lights on.
(2) Voltage Indicator - The remote control box is equipped with a voltage display. When the power supply under-voltage is less than 10.5V, the under-voltage indicator lights on, and then it needs to be charged. Charging time is 8-12 hours.
(3) Charging indicator
When connecting 220V city power, charging indicator is high, charging is normal, please turn off the power switch when charging.
(4) Red working lights
When the remote control obstacle is in the working state of interception, the red indicator above the remote control box is bright, and the power supply is switched off at the end of the interception task.
10. Main Technical Indicators
Total length of roadblock: 6000 long * 240 wide * 30 thickness (mm) |
Working Voltage: 12V |
Effective remote control distance of remote controller: 150m (open area) |
Remote Control Speed: <1/s |
Exhaust hollow steel needle: 5mm*43mm |
Weight: 16KG |
Packing box volume: 630*610*280mm |
Load bearing: 20T |
Serial number |
Annex Name |
Notes |
1 |
Remote control box |
1 sets |
2 |
Control Connecting Line |
1 roots |
3 |
Automobile Connection Line |
1 roots |
4 |
Exhaust hollow needle |
10 (with rubber sleeve) |
5 |
Charging connection |
1 roots |
6 |
Needle Fitting Tool |
1 |
7 |
Instructions |
1 copies |
8 |
Certificate |
1 copies |